Difference between revisions of "Firmware-800 Commands"
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
*[[Firmware-800 Command-060 |OUTPUT INIT (60, 3Ch)]] | *[[Firmware-800 Command-060 |OUTPUT INIT (60, 3Ch)]] | ||
| + | *[[Firmware-800 Command-066 |DUMP FIRMWARE (66, 42h)]] | ||
*[[Firmware-800 Command-071 |DUMP VERSION (71, 47h)]] | *[[Firmware-800 Command-071 |DUMP VERSION (71, 47h)]] | ||
| Line 35: | Line 36: | ||
*[[Firmware-800 Command-106 |EDIT CONFIG (106, 6Ah)]] | *[[Firmware-800 Command-106 |EDIT CONFIG (106, 6Ah)]] | ||
*[[Firmware-800 Command-107 |DUMP CONFIG (107, 6Bh)]] | *[[Firmware-800 Command-107 |DUMP CONFIG (107, 6Bh)]] | ||
| + | *[[Firmware-800 Command-108 |DUMP ALL CONFIG (108, 6Ch)]] | ||
Latest revision as of 22:27, 22 June 2018
General
This section describes the messages and commands for resetting the WiDig, obtaining version information, setting the mode of operation (stand-alone or host mode), setting the device ID, setting MIDI out operation, setting running status and obtaining COM port status. These commands have the same effect both in stand-alone and host mode.
Standalone Mode
This section describes the programming protocol commands sent to the WiDig specifically for stand-alone mode.
Dual Mode
This section describes the programming protocol commands sent to the WiDig to configure sensor inputs and actuator outputs that can be used in both host mode and stand-alone mode.
