Difference between revisions of "Firmware-810 Message-033"
| (2 intermediate revisions by the same user not shown) | |||
| Line 6: | Line 6: | ||
{| | {| | ||
| − | | | + | |0zyyyxxx: |
| − | | | + | |xxx = [0..7]; sensor input number |
|- | |- | ||
| | | | ||
| − | | | + | |yyy = [0..7]; virtual input number |
| + | |- | ||
| + | | | ||
| + | |z = 0: solo disabled | ||
| + | |- | ||
| + | | | ||
| + | |z = 1: solo enabled for the sensor input only | ||
|} | |} | ||
Latest revision as of 17:28, 5 December 2019
SOLO (33, 21h)
This message contains the WiDig SOLO status. See the SET SOLO command for more information on the SOLO feature.
The [BODY] of the SOLO message is as follows:
| 0zyyyxxx: | xxx = [0..7]; sensor input number |
| yyy = [0..7]; virtual input number | |
| z = 0: solo disabled | |
| z = 1: solo enabled for the sensor input only |
