Difference between revisions of "Firmware-810 Message-033"
| Line 6: | Line 6: | ||
{| | {| | ||
| − | | | + | |0zyyyxxx: |
| − | | | + | |xxx = [0..7]; sensor input number |
|- | |- | ||
| | | | ||
| − | | | + | |yyy = [0..7]; virtual input number |
|- | |- | ||
| | | | ||
| − | | | + | |z = 0: disable solo |
| + | |- | ||
| + | | | ||
| + | |z = 1: enable solo for the sensor input only | ||
|} | |} | ||
Revision as of 02:32, 11 December 2018
SOLO (33, 21h)
This message contains the WiDig SOLO status. See the SET SOLO command for more information on the SOLO feature.
The [BODY] of the SOLO message is as follows:
| 0zyyyxxx: | xxx = [0..7]; sensor input number |
| yyy = [0..7]; virtual input number | |
| z = 0: disable solo | |
| z = 1: enable solo for the sensor input only |
